Chemicals is used for your spa?

Use : prevents scale formation on the element of water heaters, on the jets and acrylic.

Use : used to keep water clear and prevents foaming and eliminates fatty deposits.

Use : temporarily destroyed the wrong foam, the gray or yellowish. To save only when the foam remains after the pumps stopped. Shaking the bottle and put a cap at a time directly on the foam. After bathing, do an overdose of chlorine.

· Use: pipe cleaner. Things to do in each water drain. Remove the cartridge before putting 1/3 or 1/2 bottle in water and run the spa one hour. Attention can make the foam if the air valves are open or if you have switched on the air. Drain and then rinse thoroughly spa.

Use : cleaner and polisher. To make 1 to 2 times per year to make your spa easier to clean and restore its luster.

Use : Cleaner and polisher. Use once or twice a year to make the spa easier to clean and to restore its shine.

Use: kills bacteria in water.

Use : to make every day and especially after swimming to destroy bacteria in spa water.

Use : chlorination tablets rapidly dissolving. To put the need when the chlorine level is low in the spa water. It should be used with the product Activ'Clair once a week to overdose and have always crystal clear water

Use : oxidizing and clarifying. Combine with Tab+ at least one per week.

Use : stabilized chlorinating granules. To put every day to destroy bacteria in spa water.

Use : chlorination tablets to dissolve slowly. To put in a float and check the number once a week. Turn once a week is an envelope or Activ'Clair either a dose of shock treatment without chlorine.

Use : softner and aromatherapy. Help make water softner on your skin. To post a weekly basis.

Use : for cleaning the spa filters. To soak a minimum of 12 hours per month 1 time in 500ml to 10 liters of water in a plastic container.

Use : the acidity of water. This is the first to swing so that you are comfortable in the spa water. Must be between 80 to 120 ppm.

Use : the hardness of water. This is the second of water to be swinging. Have a certain amount of calcium in the water will prevent scale from forming on the heater and the piping. If not well balanced, it can cause the foam. Must be between 140 to 180 ppm.

Use : to raise the pH of the water, to control the acidity of water. The pH should be between 7.4 and 7.6 for you to be comfortable and that the disinfectant of your choice to be active longer.

Use : to reduce the pH of the water, to control the rate base (alkalinity water). The pH should be between 7.4 and 7.6 for the effectiveness of disinfectant at their best, avoid the formation of tartar and water to prevent disorder.